1.Introduction:
TJ-56-678 is a Electromagnetic Swinging Device Circuit Electronic Soldering DIY Kit as know as swing or wiggler or wobbler. Automatically swing by magnetism from coil and magnet.
It can not only be used as a DIY electronic kit that allows you to better understand the circuit and learn how to soldering, but also as a very suitable experimental workbench tool.

2.Feature:
1>.Automatic control swinging device
2>.RGB LED Automatic Flashing
3>.Simple Operation

3.Parameter:
1>.Work voltage: DC 5V
2>.Power Type: DC-005
3>.Work Temperature:-40℃~85℃
4>.Work Humidity:5%~95%RH
5>.Size(Installed):99*59*164mm

4.Note:
1>.A3144 Hall Sensor must be placed above the metal axis of the coil, not above the copper wire of the coil, otherwise it cannot swing normally.
2>.The magnet cannot remain stationary for a long time (5 seconds) after power ON, otherwise it will cause damage to the components.

5.Installation Manual & Schematic: