1.Introduction:
This acrylic Christmas tree is a cool DIY project for the holiday decoration. It's a very simple making kit and also has a variety of LED color gradient modes. It has two Christmas trees above and each Christmas tree is combined by two tree shape acrylic, so that you can see the Christmas Tree in any angle.

The bottom is built by the long oval shape PCB and acrylic, and each part is added a 5mm full color LED refraction effect. A variety of gradients color changing is all control by the main chip that create a colorful Christmas tree making kit. In order to conform the Christmas holiday theme, the PCB add some different & funny Christmas patterns to increase the festival spirit.

2.Feature:
1>.7 kinds RGB backlight LED full color flashing effect
2>.Automatically switch LED flashing status by re-start power switch
3>.ON/OFF Christmas music playing
4>.5mm RGB LED high brightness
5>.DIP components design and easy for beginner
6>.Micro USB power supply method

3.Parameter:
1>.Work Voltage:DC 5V
2>.Work Temperature:-40℃~85℃
3>.Work Humidity:5%~95%RH
4>.Size(Installed):150*55*133mm

4.Use Methods:
1>.Connect to the 5V power supply by Micro USB cable.
2>.Turn ON/OFF the Toggle Switch can turn ON/OFF work power and switch next LED Flashing Status.
3>.Note: You can connect power wire to ‘ + ’ and ‘ - ’ pads if don't use USB get voltage.

5.Component Listing:
  1pcs DIP-8 STC8G1K17A IC Controller
  1pcs Micro USB Socket
  1pcs Toggle Switch
  3pcs 4pin 5mm RGB LED
  1pcs 80cm USB Power Wire
  4pcs Acrylic Board
  4pcs M3*18mm Screw
  8pcs M3 Nut
  1pcs 120*30mm PCB

6.Installation Steps: